Dome Camera Installation Manual Weatherproof and Indoor versions www. Contents Introduction. Menu System Manual. Page 4 of 1. THE DENNARD TYPE DOME CAMERA. The Dennard Dome Camera is a precision unit, offering a wide. The Dedicated Micros Camera has a number of features which can be selected by the System. Supervisor when the dome is installed. Any of these can be.
|Published (Last):||6 August 2014|
|PDF File Size:||9.95 Mb|
|ePub File Size:||3.79 Mb|
|Price:||Free* [*Free Regsitration Required]|
Video The co-ax and power wires are always connected, the RS wires are only connected when an external protocol converter is fitted or an RS controller is being used. Reset the Dome software reset 1. Remove and retain the four screws securing the shield to the head and lift off the shield.
Posted April 3, The connector mates with the dome as shown in the image below. Electrical Connections – Weatherproof Dome The Dedicated Micros external connections are via an IP66 Amphenol connector with 3 metre composite cable flying lead that can be extended to 30 metres max.
Lift the dome to the bracket flange ensuring head of screws pass through the keyhole slots. I believe that the setup was UTC when previously installed so would denard thought that the camera protocols would be set already.
Also, do I need to terminate the power and control twisted pairs that are also in the pigtail with the coax? Dome spins continuously DM controllers Cause No joystick dead band recognized as joystick was off centre during powerup.
Dedicated Micros Dennard 2060 Dome with 36x optical zoom
To Frame the image from a Fixed attitude camera; The link must be left on permanently. Attach bond to a suitable secure position in the ceiling void. It should be connected between the mounting dejnard on the dennaed and a suitable secure position, either on the bracket or within the ceiling void. Open the Technician Menu see Operation and Programming manual for details on accessing the menu.
Always support dome with bond prior to mating connector.
Fit the cavity plugs A to the holes. Dedicated Micros range extended to include a new indoor dome. The bracket casting can be oriented to position the cable entry hole below, on either side of at the top.
By pressing ‘print’ button you will print only current page. The dennafd of the switches is also shown. Indoor domes are rated to IP50 and are not sealed against water ingress.
Clip safety bond to the mounting bracket eyelet A on flange of bracket to secure. Electrical Connections – Weatherproof Dome Electrical Connections – Weatherproof Dome The Dedicated Micros external connections are via an IP66 Amphenol connector with 3 metre composite cable flying lead that can be extended to 30 metres max.
Dedicated Micros 2060 Installation Manual
Locate SW3 on the main PCB adjacent to the mounted connector attaching the daughter dejnard housing the yellow and blue address switches. Select the protocol required 2. Servicing is required when the apparatus has been damaged in any way, such as power cord or plug is damaged. OK, I have completely refurbished the dome housings and finally got around to testing the setup but I cannot seem to get any activity from the cameras.
Termination All Dedicated Micros domes are fitted with a termination switch, shown above. Check the continuity on the power and video cables. Locate SW3 on the main PCB adjacent to the mounted connector attaching the daughter board housing the yellow and blue address switches. Solution Reboot the controller with the joystick self centred.
Check the Input and Output voltage 2. Up The Coax Configuration Scan across the table to identify the values for the blue and yellow switches.
Dedicated Mircros Dennard Installation manual |
Dedicated Micros Operation Manual pages. Remove the selected tile that will have the dome mounted to it. Appendix A DM Fixed Attitude Dome Camera – Setup Telemetry cameras can be positioned remotely, fixed atitude cameras require manual adjustment to position the camera. Dome in co-ax mode requires video level be set to 1V p-p.